How To Jump a Car

For many of us, the prospect of jump-starting our vehicle can be intimidating. While the process is not difficult, if it is done incorrectly it can be dangerous. Being stranded someplace in the street in light of the dead battery isn’t an interesting situation for common drivers. What’s more, in the event that you’ve been there, odds are it could happen to you again.

If you’re the type who just relied on kind people to jump-start the car for you then maybe it’s time to turn things around. Learn how to jump-start the car yourself with these easy steps.

1. Determine the location of your battery. Pop the hood and check which side your battery is located. If you are not sure where it is, consult your owner’s manual. It is also important to determine the location of the battery in the car providing the jump to position it correctly next to yours.

2. Get things ready. To jump-start the car, you need jumper cables, safety glasses and a car that has a fully charged battery with similar voltage as the other car’s dead battery. Although not necessary, you can use a wire brush and rubber gloves. Position the car providing the jump correctly. Nothing is more frustrating than having the car that you are getting a jump from in the wrong location where your jumper cables cannot reach. You should park the car close enough where the jumper cables will reach both cars’ batteries comfortably. Open the hoods on both of your cars and secure them so they will not close. Make sure that the car providing the jump is shut off

3. Examine the battery. Every battery contains electrolyte solution with sulfuric acid. Important: Never jump batteries with a frozen electrolyte or if the battery is frozen. It could cause the battery to explode. You can check whether the electrolyte solution is frozen or not by taking away the detachable vent caps in some batteries. And if you crack in the battery’s casing, don’t jump-start it. Instead, purchase a new one.

4. Ensure that the batteries of the two cars have equal voltage. See to it that the two cars are not touching each other and that each ignition is off.

5. Study the battery. A battery has two poles. One should be marked as positive (+), and the other end is negative (-). You could tell which is the positive terminal since often it comes with a cover and a clump of wires while the negative one comes exposed to only one black cable.

6. Attach cables in a certain order. Using one of the cables, connect one end of it to the positive pole of the dead battery while the other point of that same cable should be connected to the positive pole of the other vehicle. Using another cable, connect one end of it to the starting vehicle’s negative terminal while the other end is attached to the vehicle with a dead battery, particularly to its engine block.

7. Get ready and stand away from the hood of the cars. Put away cigarettes if you’re smoking. Always put on safety glasses as you do this. Get the vehicle with the functioning battery started.

8. Leave it for five minutes. Then start the vehicle that was not starting. If ever it does not work, wait a little longer before doing it again.

9. Start your car. Turn your key in your ignition to see if your car will start. If it does, follow the next steps.

10. Clamp removal. Remove the black clamp from the vehicle providing the car jumping and then the red clamp. Again, do not allow any clamps to touch. Remove the clamps from your car in the same order, black followed by red.

It is important to take your vehicle to your technician after jump starting to determine if you need to replace your battery, battery cables or contacts. It is also recommended that they do a full checkup of your vehicle’s electrical systems to make sure there are not any other factors that led to your battery’s in-operation. Keep this info in your back pocket, and you’ll never have to worry about how to jump-start a stalled car ever again.